Setting Bookmarks; Safety Stop Timer - Uwatec Galileo luna Mode D'emploi

3. diving with Galileo
If you have set a reference bearing, arrows
will appear to the left or to the right of the
numeric bearing indication, to show you in
which direction you should turn in order to
match the set bearing. As an additional aid
in navigation, Galileo automatically marks
the positions at 90 and 120 degrees to
the left and to the right of the set bearing,
in addition to the position at 180 degrees
(as an aid for square-course, triangular-
course and reciprocal-course navigation
respectively). These are denoted with ┴ , ∆
and .
The left button ("BooK") still allows you to
set bookmarks.

3.4.2 Setting bookmarks

By pressing the left button (BooK") you
can set any number of bookmarks as
reminders of particular moments during the
dive. In cLaSSic, fuLL and coMPaSS
configurations, setting a bookmark also
resets the stopwatch.
When you set a bookmark, Galileo
will display the confirmation message
BooKMarK Set (if the safety stop timer
is visible on the display, the message is not
displayed. In fuLL and GauGe display
configurations it also does not show, since
the reset of the stopwatch is already an
indication that the bookmark was set
successfully). The bookmarks will appear
on the dive profile in SmartTRAK.
52

3.4.3 Safety stop timer

At the end of a dive, at depths of
6.5m/20ft or shallower and if there are no
decompression obligations, the left button
label changes from "BooK" to "tiMer"
(unless the option is turned off, see
section 2.3.3).
If Safety StoP tiMer in diVe
SettinGS is set to autoMatic:
If a minimum depth of 10m/30ft has
been reached during the dive, at a depth
of 5m/15ft the safety stop timer will
automatically start a countdown and a
bookmark will be added to the dive profile.
If you go below 6.5m/20ft, the timer will
disappear and the no-stop time is shown
again. Upon returning to 5m/15ft, the timer
will start again automatically. As long as
you are shallower than 6.5m/20ft and there
are no decompression obligations, you
can press tiMer to start or restart the
countdown manually.
If Safety StoP tiMer in diVe SettinGS
is set to ManuaL:
At a depth of 6.5m/20ft and shallower
pressing tiMer will activate the safety
stop timer and add a bookmark to the
dive profile. You can restart the timer any
number of times. If you go below 6.5m/20ft,
the timer will disappear and the no-stop
time will be shown again. You need to
press tiMer again upon ascending over
6.5m/20ft to restart the timer.
If Safety StoP
SettinGS is set to off:
It is not possible to activate the safety stop
timer.
tiMer in diVe