Entering Level Stops; Mb Stop Ignored - Uwatec Galileo luna Mode D'emploi

in underwater photography for example
are known to momentarily affect the
communication between Galileo and the
Smart transmitter.
Galileo can warn you when the signal from
the transmitter is disturbed:
- If Galileo receives no signal from the
transmitter for 30 seconds, an audible
sequence goes off and the message
no PreSSure SiGnaL appears on
the display for 12 seconds.
- If after another 40 seconds Galileo
still has not received any signal from
the transmitter, another audible
sequence goes off and the message
PreSSure SiGnaL LoSt appears
for 12 seconds, after which the RBT is
not displayed any longer and the tank
pressure is replaced with – – – .

2.6.9 Entering level stops

(default: OFF)
When diving with a microbubble (MB) level
different than L0, Galileo can warn you
when you are no longer in the MB no-stop
phase.
See section 3.5 for more information on MB
level diving.
During the dive, when you are about to
enter the level stop phase and the warning
is set to either ViSuaL or BotH, Galileo
2. Menus, settings and functions
will show the message enterinG LeVeL
StoPS on the display for 12 seconds. The
following figures show the actual display in
the cLaSSic and fuLL configurations.
If Galileo was set to LiGHt, at this point
it switches to cLaSSic to fit all the
information.

2.6.10 MB stop ignored

(default: BOTH)
When diving with an MB level higher than
L0 and in the presence of MB level stops,
Galileo can warn you if you reach a depth
shallower than the deepest required MB
level stop, therefore allowing you to avoid
missing the required stop.
During the dive, if you ascend shallower
than a suggested MB stop depth and the
warning is set to either ViSuaL or BotH,
Galileo will show the message MB StoP
iGnored on the display for 12 seconds
and the depth is shown in inverted colors
29