Warning Settings - Uwatec Galileo luna Mode D'emploi

2.6

Warning settings

Galileo can warn you about specific
situations that might require an action on
your part.
Warnings represent situations that require
the diver's attention, but ignoring them does
not represent an immediate risk. It is up to
you to decide which ones you would like to
be active and which ones not. All warnings
can be off, ViSuaL only, audiBLe only,
or BotH visual and audible. The audible
warning consists of three short sequences
of beeps. The visual warning is described
independently for each case.
2. Menus, settings and functions
If a warning is set to ViSuaL or BotH and
it is triggered while Galileo is in compass
mode, the display will automatically switch
back to the regular configuration (cLaSSic,
LiGHt or fuLL) in order to properly show
the warning message.
Each warning has its own submenu within
the Warning settings menu. Use the ""
or "" buttons to scroll through the list.
A highlighted bar will show the selected
submenu and the hint line at the bottom
indicates the status of the warning. Press
entr to access any submenu. At any point
in time pressing and holding the right
button will return to the Warning settings
menu without saving any unconfirmed
changes.
! WarninG
Galileo also features alarms. Alarms differ from
warnings in that they cannot be turned off, and
that their audible sequence is continuous until
the situation is corrected. These are described
in section 3.2. Alarms have priority over
warnings, and warnings will not be displayed
as long as an alarm is active.
23