Elite REAL AXIOM Mode D'emploi page 18

GB
CABLE CONNECTION
NOTE. DO NOT CONNECT THE USB CABLE TO
THE COMPUTER BEFORE INSTALLING THE
REALAXIOM SOFTWARE.
Connecting the PC to the console
Use the USB cable 9 to connect the console of the
RealAxiom to the PC.
Connect the wider flat plug to the USB socket of
the computer and the plug on the other end into
the matching socket in the console (ill. 14).
WARNING. DO NOT CONNECT THE USB CABLE
TO THE COMPUTER BEFORE INSTALLING THE
REALAXIOM SOFTWARE.
The difference of the plugs at the two ends of the
cable will avoid incorrect connections.
Connecting the console
to the resistance unit
Use the flat cable J to connect the console of the
RealAxiom to the resistance unit. The plug at one
end of the cable fits into the matching socket in the
console (illustration 14) and the plug on the other
end into the matching socket in the resistance
RealAxiom can be used without connecting it to a PC. When the console is not connected to the PC,
RealAxiom will operate independently.
The green led on the console will flash when operating RealAxiom without connecting it to a PC. The
resistance will be at minimum level when operating RealAxiom independently.
Push the "+" key on the console to increase the resistance level and push the "-" key on the console to
decrease the resistance level.
There are 8 resistance levels in total. After 20 seconds of inactivity the resistance will automatically
return to the minimum level.
18
USING REALAXIOM WITHOUT COMPUTER
unit. The difference of the plugs at the two ends of
the cable will avoid incorrect connections.
Connecting the resistance unit
Connect the plug coming from the cadence sensor
6 to the resistance unit. The socket is in the shell
of the resistance unit faced downwards.
Insert the plug coming from the resistance unit to
the mains power supply.
Make sure that the power unit R works correctly
by checking the green led on the console lights up
14
or flashes.
If the led is not on, the console-resistance unit and/
or the resistance unit-mains connection has not
been fitted correctly.
Fasten the 3 cables to the unit using the provided
cable clamps in order to prevent any accidental
damage of the connectors. See Illustration 15.
15