Erbauer ERN646ATL-I Mode D'emploi page 9

GREASE LOADING
WARNING! Always disconnect air supply from the tool before you are
loading grease.
A. Cartridge Grease Loading
1. Remove the container tube (G) from the gun body. (See Figure 1)
2. Pull back on the handle (I) until it is fully extended. Lock it into place with the locking
plate (J). (See Figure 2)
3. Remove the cap and/or lid from both ends of the cartridge (not included). Insert the
cartridge into the container tube in the orientation indicated on the cartridge, and
make sure that the cartridge is as far as possible. (See Figure 3 & 4)
4. Reassemble the container tube to the gun body. Press the locking plate to release
the handle. Press the handle in as far as it will go. (See Figure 5 & 6)
NOTE: Make sure that the end of the grease cartridge inserted into the
container tube should not be damaged or squeezed and should remain in the
grease cartridge resulting in grease not being forced out.
The grease cartridge should be an exactly round shape. Otherwise, the
plunger will be prevented from entering.
NOTE: Do not re-use the empty grease cartridge for refilling after one time
of usage.
AIR GREASE GUN