Erbauer ERN646ATL-I Mode D'emploi page 10

B. Suction Filling (See Figure 7)
1. Remove the container tube (G) from the gun body.
2. Submerge the open end of the container tube 2 inches
approximately into the grease container (not included).
3. Pull back slowly and extend the handle (I) fully to draw
grease upward into the container tube. Lock the handle into
place with the locking plate (J) when it is fully extended.
4. Reassemble the container tube to the gun body. Press the
locking plate to release the handle. Press the handle in as far
as it will go.
C. Filler Pump Filling (See Figure 8)
1. Pull back on the handle (I) until it is fully extended. Lock it
into place with the locking plate (J).
2. Insert the filler plug on the end of the hose of a filler pump
(not included) into the filler nozzle (M) of the grease gun.
3. Follow the operating instructions provided in the filler pump
manual (not included) to work the filler pump until the
container tube (G) of the grease gun is full.
4. Disconnect the grease gun from the filler pump.
5. Press the locking plate to release the handle.
Press the handle in as far as it will go.
ASSEMBLY
1. Attach the rigid coupler assembly (B) to the connector (C)
of the grease gun. (See Figure 9)
2. Remove the air inlet protective cap from the air inlet (F).
(See Figure 10)
AIR GREASE GUN