Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8 Insert the wires into the clamp.
Important
Hold the wires in place with the clamp to
prevent undue force from being applied to
the terminal block and causing cable
breakage.
9 Install the top case on the bottom case.
Two mounting tabs are at the top of the top case.
Hook those two tabs onto the bottom case, and click the top case into place. Check that the case is
securely installed and not lifted.
Important
When attaching the top casing to the bottom
casing, push it until it they click into place.
If they are not properly locked into place,
they may fall, causing personal injury,
controller damage, or malfunctions.
Direct wall installation (when running the cable along the wall)
■
• Thread the cable through the access hole at the top of the remote controller.
• Seal the cut-out part of the cover with putty.
• Use a cable cover.
Insert the wires.
Use a cable
cover.
Seal the gap
with putty.
– 13 –
Wall
Thread the cable through the top of the
remote controller.
Clamp
Should not
be lifted.
Publicité
Table des Matières
