CLIVET BOX-SL 2 Instructions Pour L'installation, L'utilisation, L'entretien page 62

3 Install the panel
– Align the front panel with the main body, taking
into account the position of the pipes and the drain
side.
– Attach the four decorative panel rings to the indoor
unit hooks.
– Tighten the screws of the panel hooks in the four
corners equally.
m
CAUTION
Tighten the screws until the thickness of the
spongy material between the main body and
the panel is down to 4-6 mm. The edge of the
panel must fully touch the ceiling.
Pipe side
Drain
side
Screwdriver
– Adjust the panel by turning it to completely cover
the opening in the ceiling.
22
Ring
Fig. 30
– Connect the two connectors of the ventilation slit
motor to the corresponding cables in the electrical
panel.
Electrical panel
Connect the
ventilation slit
motor
– Remove the foam stoppers from inside the fan.
– Fasten the side of the front grille to the panel.
– Connect the display panel wire to the corresponding
connector on the main body.
Electrical panel
– Close the front grille.
Installation
Connect the
ventilation slit
motor
Fig. 31
Fig. 32