Worx WG510 Manuel D'utilisation page 9

appliance plug as shown or described in the
Operating Instructions.
SAVE THESE
INSTRUCTIONS
SERVICING OF DOUBLE-INSULATED APPLIANCES
A double-insulated appliance is marked with one or
more of the following: The words "DOUBLE
INSULATION" or "DOUBLE INSULATED" or the
double insulation symbol (square within a
square).
In a double-insulated appliance, two systems of
insulation are provided instead of grounding.
No grounding means is provided on a double-
insulated appliance, nor should a means for
grounding be added to the appliance. Servicing a
double-insulated appliance requires extreme
care and knowledge of the system, and should be
done only by qualified service personnel.
Replacement parts for a double-insulated appliance
must be identical to the parts they replace.
SYMBOLS
To reduce the risk of injury, user must
read instruction manual
Wear eye protection
Wear ear protection
Double insulation
Before any work on the machine itself,
pull the power plug from the outlet.
Blow mode
12 AMP All-in-One Blow/Vac/Mulch
Vacuum mode
Impeller continues to rotate after the
machine is switched off. Wait until all
machine components have completely
stopped before touching them.
OPERATION
INTENDED USE:
The blower & Vac is intended for residential use only.
Use the blower outdoors to move or vacuum yard
debris as needed.
Assembly and Operation
ACTION
Assembly
Assembling the Blower/ Vacumm
Tube
Attaching the Shoulder Strap
Note: There are two positions for
attaching the strap.
Attaching the Extension Cord
Blow Mode
Starting & Stopping
WARNING:
—The tool runs for a few seconds
after it has been switched off. Let
the motor come to a complete
standstill before setting the tool
down.
—For blowing, make sure the tube
is installed in position completely,
and the vacuum cover is closed, or
else the machine can not start.
Using the Blower
CAUTION!
—Do not blow hard objects such as
nails, bolts, or rocks.
—Do not operate the blower near
bystanders or pets.
—Use extra care when cleaning
debris from stairs or other tight
areas.
—Wear safety goggles or other
suitable eye protection, long pants
and shoes.
Adjusting the Blowing Speed
Vacuum mode
FIGURE
See Fig. A, B
See Fig. C
See Fig. D
9
See Fig. E
See Fig. F
See Fig. G
EN