Symbols Used - Bell Pickpine VS K9 N Mode D'emploi Et D'entretien

1.1 - Symbols used

Standard graphic symbols are used on all machines in order to ensure complete safety of all parts of the log splitter.
As these symbols are very important, read the information below attentively.
it is obligatory to read the machine's use and maintenan-
ce manual in full before using the machine.
it is obligatory to wear safety footwear at all times to
provide protection against the risk of logs accidentally
falling on feet.
it is obligatory at all times to wear gloves which protect
the hands against chips and splinters which may be
produced during work.
it is obligatory at all times to wear goggles which pro-
tects the eyes against chips and splinters which may be
produced during work.
in normal conditions of use, our machines may expose
the operator daily to noise levels lower than or equal to
85 dB(a). it is therefore obligatory to wear ear defenders.
it is obligatory at all times to wear a helmet which pro-
tects the hands against chips and splinters which may
be produced during work.
The log splitter must be used by one person alone.
it is forbidden to remove or tamper with the protection
devices and safety devices.
it is forbidden to carry out any maintenance work or to
renew parts on the machine when it is running.
18
it is forbidden to stand in the range of action of the
machine. apart from the operator, no other person or
animal may be present within a radius of 5 metres from
the machine.
Dumping of used oil in the environment is forbidden. The
oil must be disposed of according to current legislation in
the country where this operation is carried out.
Warning: never remove a log trapped in the wedge with
your hands.
Danger of cutting or crushing of the hand: never touch
hazardous areas while the wedge is moving.
Danger of cutting or crushing of the hand: never touch
hazardous areas while the wedge is moving.
Hitch point
Two hands control: activating both the levers downwards,
the wedge will start working and cut the log
Once the log is splitted, push the levers upwards in
order to bring the wedge in the upper position, ready to
a new work cycle
D22002600 - v.0 - UPD 210715
ENGLISH