Trebs Comfortice 99218 Mode D'emploi page 17

5. Ice making cycle begins. The evaporator in the water tray starts to form ice onto the
evaporator fingers.
6. It takes about 6 to 18 minutes (depending on the water temperature) for the ice making
cycle to complete. Once completed, the water tray will tilt forward; the remaining water
will flow back to the water reservoir and the ice cubes will drop from the fingers. You will
hear a sound as the ices cubes are released. Ice are dropped to the ice basket directly.
7. In about 30 seconds, the water tray will tilt backward. Once the water tray returns to its
leveled position, the second ice making cycle begins.
8. Press "OFF" to stop the machine.
9. If is on, if still want to make ice, then add water to the water tank , same as step
2.
Noted: please take out the ice first, then add one full cup of water, so as to avoid
overflow of water when the ice melt.
10. Also you can set the clock, automatically turn on and turn off time via following steps:

Set clock: press button "TIME" once, and press "SET" to change the hour, press
button "TIME" twice, and press "SET" to change minute, after setting the right time,
the clock is set successfully.

Turn On: press button "TIME" three times, to set hour, press four times to set
minutes, waiting for 5 seconds, the "ON" indicator will turn off, then press "SET"
twice, the "TIME" and "ON" indicator in front of the time is on, this setting is
finished.
11. Turn off: press button "TIME" three times ,to set hour, press four times to set minutes,
waiting for 5 seconds, the "OFF" indicator will turn off, then press "SET" three times, the
"TIME", "ON" and "OFF" indicator in front of the time is on, this setting is finished.
12. When is on, please pull the drawer out, and take out the ice with the ice collecting
tray.
Notice: For best performance, water temperature should be between 7°C and 35°C and
ambient between 15°C and 38°C.
Care and Cleaning / Maintenance

To ensure the cleanliness of the ice cubes, water in the water reservoir should be
replaced every 24 hours.

Remove the drain plug to drain remaining water from the water reservoir when the ice
maker will not be used for long period of time.

Notice: Screw the drain plug back in place after the water has been drained. If the cap is
lost, please call the distributor.

Always change with fresh water before starting ice production at initial installation or
after long shut-off periods.

Please clean your ice maker regularly. When cleaning, unplug the unit and remove the
ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside
surface of the ice maker. Do not spray ice maker with chemicals or diluted agents such as
acids, gasoline or oil. Rinse thoroughly before starting.
17