Select Cycle - Whirlpool WTW7990XG0 Guide D'utilisation

8.

Select cycle

Use the touch screen to select the desired cycle. Cycles
are grouped in tabs by type, and the last 7 cycles used
will appear in the Recent tab. Touch the
to scroll left or right.
The Normal Clothes cycle is recommended for washing
normally soiled cottons, linens, and mixed fabric loads.
For additional information on cycles, options, and features,
touch Learn More on your washer display.
9.
Select cycle settings and options
You may choose cycles from the Recent tab, with any custom
settings you have selected. Or select a cycle from the Clothes,
Colors, Bed & Bath, or Classic tab to use default settings or
choose new custom settings.
Once you have selected the cycle, default settings for the
cycle will be displayed. If you wish to change the default
settings, you may adjust the settings using the easy select
screen, by selecting the desired settings individually, or use
Stain Assist to get recommended settings for the stain.
Once the desired settings and options are selected, press
START/PAUSE, or touch Delay Start to set the washer to start
at a later time.
NOTE: Not all settings and options are available with all cycles.
Always read and follow fabric care labels instructions
to avoid damage to your garments.
10.
You can delay the start of the wash cycle by up to 12 hours.
Touch the Delay Start button, and drag the time selector to
and arrows
the desired start time. You may also touch the 15 min. up and
down buttons to adjust the start time in 15 minute increments.
The start time and estimated end time will be displayed. Once
the desired start time is set, press Start Delay to confirm and
start the countdown.
11.
Touch the START/PAUSE button to start the wash cycle.
When the cycle has finished, a "clean" message will be
displayed and the end of cycle signal will sound (if set).
Promptly remove garments when cycle is done to avoid
odor, reduce wrinkling, and rusting of metal hooks, zippers,
and snaps.
NOTE: If you need to open the lid to add 1 or 2 missed
garments, \you may do so while Add a Garment is displayed.
Press START/PAUSE; the lid will unlock once the washer
movement has stopped. This may take several minutes if the
load was spinning at high speed. Then close lid and press
START/PAUSE again to resume the cycle.
If lid is left open for more than 10 minutes the water will be
pumped out.
Set a delayed start, if desired
Touch START/PAUSE to begin
wash cycle
11