Michelin 009556 Notice D'utilisation page 8

Study, understand, and follow all instructions provided with and on this device. Do not exceed rated capacity. This is a lifting device only. After
lifting, immediately transfer the load to appropriately rated jack stands. Never work on, under, or around a load supported by this device. Use
only on hard, level surfaces capable of supporting the load marked on the equipment. Do not move or dolly loads with this device. Failure to
heed this warning may result in personal injury and/or property damage.
To avoid any risk of being crushed or sustaining other injuries: NEVER work on, under or around a load supported only by a jack. ALWAYS use
adequately rated jack stands. If the generated efforts exceed 40kg, the effort shall be lowered by additional person.
Be sure all tools and personnel are clear before lowering load. No alterations shall be made to this device. Only attachments and/or adaptors
supplied by the manufacturer shall be used. Only lift the vehicle using the jacking points specified by the vehicle manufacturer.
• This product should not be used in difficult conditions (eg extreme climates, applications in gel, strong magnetic fields). Or during an
operation subject to special rules (eg potentially explosive atmospheres, mines). Or duringThe lifetime of the product is 5 years. It is forbidden
to use this product to lift people. It is forbidden to handle loads, whose nature could lead to dangerous situations (such as molten metals,
acids, radiating materials, especially the fragile loads). If the product is out of service it must be destroyed. The product should not be in direct
contact with food. The product should not be used on vessels. The standard oil must not stray from shelter. In case of accident or breakdown,
a blockage is likely to happen, thank you for contacting the customer service IMPEX phone: +33 (0)4 76 32 69 37 email: michelin@impex.
fr. The working method to follow to help unlock the equipment safely. When changing parts to contact the customer service IMPEX phone:
+33 (0)4 76 32 69 37 email: michelin@impex.fr. It is necessary that the operator can monitor the hoist and the load at every movement. It
is not allowed to work under the load lifted until it is secured with appropriate means. All necessary information concerning the formation
and the forces of pumping and translation must be provided to the operator. When the hydraulic system is reloaded, the characteristics of the
hydraulic fluid used in the jack and the hydraulic fluid level as indicated by the manufacturer shall be observed. Check regularly the markings
if they are identical to the initial marking. The jacks shall be maintained and repaired to manufacturer's instructions. The maintenance and the
repairs must be performed by qualified personnel. No changes may affect conformity with the jack to the standard EN 1494 : 2000+A1 : 2008
shall be performed.
OPERATION
Lifting (refer to Fig.1, page 2)
1. Place vehicle in park, with emergency brake on and
wheels securely chocked to prevent inadvertent
vehicle movement.
2. Locate and close release valve by turning handle
clockwise until firm resistance is felt to further thread
engagement. Center jack saddle under lift point.
3. Verify lift point, insert handle into handle sleeve and
pump to contact lift point. To lift, pump handle until
load reaches desired height.
4. Transfer the load immediately to appropriately rated
jack stands.
5. Please just indoor use to avoid wind pressure
EN
WARNING !
Lowering
1. Raise load high enough to clear
the jack stands, then carefully
remove jack stands (always used
in pairs).
2. Slowly turn the handle anti-
clockwise, but no more than a
1/2 full turn.
3. After removing jack from under
the load, push saddle down to
reduce ram exposure to rust and
contamination.
8