Philips AVENT SCD505 Manuel D'utilisation page 14

Why don't I hear a sound? Why can't I hear
my baby cry?
• Increase the volume of the parent unit.
• Increase the microphone sensitivity.
• Reduce the distance between the baby
and the baby unit.
Is my baby monitor secure from
eavesdropping and interference?
• The DECT technology of this baby
monitor guarantees no interference from
other equipment and no eavesdropping.
Why does the parent unit react too quickly to
other sounds?
• Remove the sound sources away from
the baby unit.
• Decrease the microphone sensitivity of
the baby unit.
Why does the parent unit react slowly to the
baby's crying?
• Make sure that the microphone of the
baby unit faces the baby.
• Move the baby unit closer to your baby
with a minimum distance of
3.5 feet/1 meter.
• Increase the microphone sensitivity.
Why do the non-rechargeable batteries of
the baby unit run low quickly? How can I save
battery power?
• Decrease the speaker volume or the
microphone sensitivity.
• When the baby unit is not in use, turn off
the nightlight and the baby unit.
• Enable ECO mode.
The specific operating range of the baby
monitor is 1000 feet/330 meters. Why does
my baby monitor manage a much smaller
distance than that?
• The specified range is only valid outdoors
in open air. Indoors, the operating range
is up to 150 feet/50 meters.
14 EN
Why is the operating time of my parent unit
shorter than 24 hours?
• When the parent unit is charged for the
first 4 times, the operating time is less
than 24 hours. The rechargeable battery
pack only reaches its full capacity after you
charge and discharge it at least 4 times.
• Decrease the volume and the
microphone sensitivity.
Why does the charging time of the parent unit
exceed 8 hours?
• For the first time or after a long period of
non-use, the charging time is 10 hours.
• Switch off the parent unit during charging.
What happens during a power failure?
• If the parent unit is sufficiently charged
and there are batteries in the baby unit,
the baby monitor continues to operate
during a power failure.