Moulinex ZU600110 Mode D'emploi page 68

Common faults
The appliance cannot be turned on
The appliance will not start, and the
indicator lamp flashes
The appliance stopped suddenly during
operation, and is beeping
The filter has been scratched
Very little juice is extracted
There is a lot of water in the pulp
The rubber scraper does not rotate
during operation
The juicing bowl shakes slightly when
the machine is turned on
The safety lid cannot be opened after
juicing
68
Handling method
Check if the plug has been plugged in properly.
Check if the juicing jug has been fitted properly.
Check if the juicing or jam bowl has been fitted
properly, and check if the safety lid is properly
aligned.
Is the appliance is clogged from excessive
feeding (too many pieces or pieces too large)?
Put the appliance into "Reverse" mode and let it
run for 5 seconds.
Has the appliance entered its safety mode after
working continuously for more than 20 minutes?
Solution: Allow the appliance to rest for
30 minutes, then try again.
If you are unable to restart the appliance, get in
touch with our customer service.
The gap between the filter and the rubber scraper
is very small; do not run the appliance when empty.
Water content varies between different fruits and
vegetables.
Fruits and vegetables also produce less juice when
they lose their freshness.
When juicing hard fruits and vegetables, check
that the pulp lever control is in the "Open"
position
When juicing soft fruits and vegetables, check
that the pulp lever control is in the "Closed"
position.
Check if the gear (L) at the base of the juice bowl
has not deteriorated, if so contact your customer
service
Slight shaking of the juicing bowl during
operation is normal.
There could be too much residual pulp in the
machine. Turn the lever (F) in open position,
press the reverse button and allow the machine to
run in reverse mode for 5 seconds.
If you are unable to resolve the problem after
trying the above, get in touch with our customer
service.