Automatic Boost Function; Bridging Function - Pyramis 2405000000 GA1 Mode D'emploi Et Instructions De Montage

Table de cuisson vitrocéramique à induction
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34
Operation
cooking
level
reduction
Press and keep pressed (for approx. 3 seconds)
Selected cooking

Automatic boost function

level
1
2
3
4
5
6
7
8
9
28
Time (min:sec)
0:40
1:12
2:00
2:56
4:16
7:12
2:00
3:12
-
Automatic boost function
Food is parboiled at power setting 9 with the automatic boost function. After a
certain time, the power level will switch down automatically to a lower
simmering setting (1 to 8).
When using the automatic boost function only the simmering setting with
which the food is to be cooked through needs to be selected since the
electronic unit switches down automatically.
The automatic boost function is suitable for dishes which are cold initially and
are then heated up at high power. These dishes do not need to be constantly
monitored when simmering (e.g. boiling meat for soups).
1. Switch on the hob.
2. Press the touch control
seconds) to activate the function and immediately select a specific
simmering setting:
........ left .......................... simmering setting 1
........ centre..................... simmering setting 4
........ right........................ simmering setting 8
The symbol A will light up. This will activate the automatic boost function.
A and the selected simmering setting will blink alternately.
3. The automatic boost function will operate as programmed. After a certain
time (see chart) the cooking process will be continued with the simmering
setting. The A symbol will go off.
Notes
• The simmering setting can be raised while the automatic boost function is
in operation. A reduction in the simmering setting will switch off the
automatic boost function.

Bridging function

The front and the rear cooking zones may be activated together for a cooking
process (bridging function). This enables larger cookware to be used.
1. Switch on the hob.
2. Press the touch control
zones simultaneously to activate the bridging function.
The bridging function is activated, the symbol
Operation is carried out with the touch control
cooking zone.
3. To deactivate the two touch controls
simultaneously again or switch off the hob.
Note
The roaster or the pot will need to cover at least half of the cooking zones
used in order to be recognised by the pan recognition device!
GB
and keep it pressed (for approx. 3
of the rear and front cooking
appears.
of the front
press them

Publicité

Table des Matières
loading

Produits Connexes pour Pyramis 2405000000 GA1

Table des Matières