Rane Twelve Guide D'utilisation page 4

Setup
Before getting started:
• Read the Safety & Warranty Manual before using Twelve.
• Make sure all items listed in
are sold separately.
1. Assemble the Platter System
1. Remove the Twelve base from the packaging. Remove the platter assembly from the
package (underneath Twelve). Place Twelve on a flat, stable surface for assembly and
operation.
2. Place the platter onto the Twelve base by aligning the pins in the
bottom of the platter with the holes in Twelve's motor. Press it
down firmly. Check to make sure that it rotates uniformly and does
not wobble excessively.
3. Place the slipmat onto the platter, then place the vinyl over the
slipmat.
4. Line up the notch in the spindle with the screw in the spindle lock
adapter. Use the allen wrench (included) to tighten the screw,
locking the adapter to the spindle.
Note: By pressing down on or lifting up the vinyl while you tighten
the spindle screw, you can adjust the slip friction to your preferred
feel.
4
Introduction > Box Contents are included. Items not listed