Beta 1471M/C22 Mode D'emploi page 4

INSTRUCTIONS FOR USE
Pneumatic tool for rotating and pushing back brake pistons
ATTENTION
Always follow the instructions provided by the vehicle manufacturer. For use by trained
personnel only.
To maintain an acceptable noise level, do not exceed 8 bar pressure.
The tool is designed to be used with 5-8 bar pressure.
How to Use
1. Choose an adapter suitable for working on the brake caliper piston. Fit it onto
magnetic end (1). Connect the tool to the compressed air line, making sure that it
does not exceed 8 bar pressure.
2. Press release button (2) and operate lever (3) to move the push rod forward or
backward and fit the tool into the caliper.
3. Press button (4), while rotating lever (3), to rotate the brake caliper piston.
4. After pushing the piston backward, press button (2) and pull lever (3) to move the
push rod backward, releasing the tool from the caliper.
Information on adapters:
0 - GM
2 - Citroen, Honda
3 - VW, Land Rover
4 - Alfa Romeo, FIAT, FORD, GM, HONDA,
MAZDA, SAAB, TOYOTA,
5 - Adattatore da 3/8"
6 - NISSAN, VW
7 - Alfa Romeo, Audi, Citroen, FIAT, FORD,
HONDA, Jaguar, Lancia, NISSAN,
PEUGEOT, Renault, Rover, SAAB, Seat,
SUBARU, TOYOTA, VW, Volvo
8 - GM
9 - GM
WARRANTY
We accept no responsibility for damage caused by misuse or any use that is not in
compliance with the safety standards described herein.
4
ART. 1471M/C22
A - Renault
B1 - Ford
B2 - Iveco Daily
B3 - BMW
B4 - BMW
B5 - Mini / BMW
E - FORD, NISSAN
F - Opel
M - FORD, MINI
N - Alfa Romeo, Audi, Lancia, SAAB,
Honda, VW
K - Citroen
W - Passat VW
EN