Forch Powerwash Bio Mode D'emploi page 58

4.4 ENERGY SAVING MODE (temporarily lowering the temperature to 30°C)
In ECO-mode the temperature of the degreasing bath can be lowered for a certain time in order
to reduce power consumption. After this time the temperature rises again to normal operating
temperature (the duration can be changed – see paragraph 6).
HEATINH-display
extinguished
Keep ECO-display flashing
4.5 IMMERSION OPERATION
IMMERSION PROCESS:
Close the basin outlet by inserting the drain cover.
■
Place the part to be cleaned into the basin.
■
Cover the basin again with the rectangular sheet metal cover.
■ Take the brush off the brush holder.
■
Press the button for pump control to fill the basin.
Check that there are no residues (chips, sand, etc.) in the contact area of the drain cover. Clean the
area with a brush if necessary.
The drain cover allows the liquid to drain off into the tank and creates a continuous flow in the basin
which ensures good cleaning.
Make sure that the overflow hole is not blocked.
For immersion the drain cover has to be placed in the correct direction.
Temperature reached ->
Temperature is kept
Attention:
Do not immerse the parts longer than necessary for the cleaning.
Check the material compatibility before prolonging immersion time.
T° = 30°
Green indicator light
flashes. If temperature
is reached the green
light flashes slowly.
T° = 38°