THOMSON RCD203U Mode D'emploi page 20

SAFETY RECOMMENDATIONS
Use
Never move the appliance while you are using it, since this
o
could damage it and affect the disk. Remove the disk before
you move the appliance.
If the appliance is moved directly from a cold location to a
o
hot location, condensation may form on the lens located
inside the disk compartment. As a result the appliance may
not work properly. In that case, remove the disk and leave
the appliance switched on for at least 30 minutes until the
humidity has completely evaporated.
Disconnect the appliance from the power source:
o
- if it is not going to be used for a long time,
- if there is a thunderstorm,
- if it isn't working properly.
This appliance has been designed solely for domestic use;
o
the manufacturer's liability shall not be engaged in the event
of any professional use, by any misuse or by any use not
complying with the operating instructions.
This appliance is not a toy; keep it away from children. We
o
recommend only letting children use the appliance under the
supervision and responsibility of their parents.
Never let children insert foreign objects into the appliance.
o
Due to the effect of electrostatic and/or fast electrical
o
transient phenomena, the product may not operate properly
and will need to be reset by the user.
EN 16
PORTABLE CD RADIO
RCD203U / RCD204U / RCD205U
Warning concerning the electrical cable
Do not use the appliance if it or the electrical cable is faulty.
o
If the electrical cable is faulty it must be replaced by an
o
identical cable (complies with EN60320).
You are recommended to plug appliances into a dedicated
o
circuit: they must not be plugged into a multi-plug, instead
they must be directly plugged into a mains socket. Do not
overload mains sockets. Overloaded, loose or damaged
mains sockets, frayed electrical cables, extension cords, or
cracked or damaged insulation wires, are dangerous. These
situations can cause a fire or an electrical discharge.
Inspect the radio's electrical cable regularly, and if it shows
o
signs of weakness unplug it. Do not use the appliance until
the electrical cable has been replaced by a qualified person.
Protect the electrical cable from physical or mechanical
o
stresses: make sure that it is not distorted, tangled, pinched,
stuck or crushed. Pay particular attention to the plugs, mains
sockets and the electrical cable where it exits from the
appliance.
Disconnect the cable from the mains power supply by
o
grasping the electrical cable's plug. Do not pull on the cable.
When you install the radio make sure that the plug can
o
be accessed easily, so that it can be unplugged quickly if
necessary.