Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
If the appliance does not start or it stops during
operation. Before you contact an Authorised
Service Centre, check if you can solve the problem
by yourself with the help of the information in the
table.
Problem and alarm code
You cannot activate the appli-
ance.
The programme does not start.
The appliance does not fill with
water.
The display shows
The appliance does not drain
the water.
The display shows
The anti-flood device is on.
The display shows
Once you have checked the appliance, deactivate
and activate the appliance. If the problem occurs
again, contact an Authorised Service Centre.
THE WASHING AND DRYING RESULTS ARE NOT SATISFACTORY
Problem
There are whitish streaks or blu-
ish layers on glasses and dishes.
There are stains and dry water
drops on glasses and dishes.
•
Make sure that the mains plug is connected to the mains sock-
et.
•
Make sure that there is no a damage fuse in the fuse box.
•
Make sure that the appliance door is closed.
•
If the delay start is set, cancel the setting or wait for the end of
the countdown.
•
The appliance has started the procedure to recharge the resin
inside the water softener. The duration of the procedure is ap-
proximately 5 minutes.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clogged.
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or bends.
.
•
Close the water tap and contact an Authorised Service Centre.
.
•
The release quantity of rinse aid is too much. Adjust the rinse
aid selector to a lower position.
•
The quantity of detergent is too much.
•
The released quantity of rinse aid is not sufficient. Adjust the
rinse aid selector to a higher position.
•
The quality of the rinse aid can be the cause.
With some problems, the display shows an
alarm code.
Possible solution
For alarm codes not described in the table, contact
an Authorised Service Centre.
Possible solution
31
Publicité
Table des Matières
