Bowers & Wilkins PX7 Mode D'emploi page 5

4. Battery Charging and Power Saving
Your PX7 comes with the battery partially charged
may be used immediately. For best practice we
recommend to fully charge the headphones before
first use. Please allow up to 3 hours for full charge.
The headphones can be used while charging.
To charge:
1. Please use the supplied charging cable and
connect the USB-A plug to a wall charger or a
powered computer USB-A socket.
2. Then connect the USB-C end to the
headphones USB-C socket
Note: During charging, the headphone indicator
will flash green. When fully charged, the indicator
will remain illuminated. See Diagram 3 for status
indicator details.
4.1 Standby Power Saving
PX7 wear detection sensors intelligently conserve
power. When taken off your head, PX7 will
automatically enter standby which will pause media
playback, disconnect Bluetooth and switch to a low
power state.
When worn again, PX7 will wake and reconnect to
the last connected Bluetooth source. Note that both
earpieces must detect wear for proper functionality.
If wear sensors are disabled using the app, this
feature will also be disabled.
With the app, you can customise how long the
headphones will wait before switching to auto
standby, please see Standby Timer under Settings
in the app.
5. Wearing Your Headphones
Wearing your headphones correctly will help ensure
the best possible experience. See Diagram 6.
1. Identify the left and right earpieces by finding
the identification legends located on the interior
of each earpiece.
2. Wear the headphones accordingly with the
headband adjusted so that the they rest
comfortably on your head.
Note: Wearing glasses that distort the profile
of your ears may interfere with headphone
performance. Similarly, hair trapped between your
ears and the headphone ear-pieces may interfere
with the wear sensor performance.
Diagram 5
USB-C cable connection
L R
Diagram 6
Wearing your headphones
5