Navman B2 Série Mode D'emploi page 12

B2 User Manual | Adding contacts to the B2
Adding contacts to the B2
You can make calls to your contacts using voice recognition. To do this, you must send contact information from
your phone or PDA to the B2. The B2 can store information for up to 400 contacts (contacts cannot be shared
between paired phones and PDAs).
Note: You must record the voice recognition keywords (see "Voice recognition" on page 11) before you can
send contact information to the B2.
How do I send contact numbers from my phone or PDA to the B2?
Note: You can only send contact information for one contact at a time.
1. Navigate through the Voice Menu to the Receive contacts sub-menu, then press
The Bluetooth connection between the B2 and your phone or PDA is disconnected.
2. Go to the Phone book, Address book or Contact list on your phone or PDA and select the contact to
send to the B2.
3. Press Options, then Send by Bluetooth.
Note: The method of selecting and sending a contact to the B2 by Bluetooth may differ depending on your
model of phone or PDA.
4. Select Navman B2-Series from the list of local Bluetooth devices.
If you are prompted for a passkey or device PIN, enter 1234.
5. Follow the prompts from the B2 to record a name for the contact. The correct categories will be assigned
to the contact's numbers automatically.
You can now call a contact using voice recognition.
How do I update contact numbers on my B2?
You can update the numbers assigned to a contact by resending the contact from your phone or PDA. You can
not delete a contact.
12
.