Packaging - Transport - Storage; Installation - Tecno-gaz PURA plus 249S2 Mode D'emploi

ENGLISH
PACKAGING – TRASPORT - STORAGE
PURA PLUS™ is wrapped in a nylon sheet and placed in a corrugated cardboard box.
Stability is guaranteed by cardboard fillers and by the accessories in the box.
Transport must be done according to the regulations regarding fragile goods.
There are no particular problems with storing the product; it is possible to stack up
to five boxes containing the same product and shelf life is unlimited if kept at a
temperature of between 0 and 50°C.
The original packaging material must be kept during the whole guarantee period,
since only with such material it is possible to transport the product without
damaging it.
Failure to comply with the above shall result in termination of the guarantee.

INSTALLATION

IMPORTANT:
A. DO NOT INSTALL UNDER OTHER TAPS THAT COULD WET THE WATER CLEAN.
B. DO NOT INSTALL NEAR SOURCES OF HEAT .
C. DO NOT INSTALL PURA PLUS™ OUTSIDE, FROST WOULD DESTROY THE
DEVICE.
D. THE PURA PLUS™ INSTRUMENT SHOULD BE POSITIONED WITH ITS OUTLET
FITTING AT A HIGHER LEVEL THAN THE INLET FITTING OF THE AUTOCLAVE. IF
THIS IS NOT DONE, THE TAP LOCATED ON THE OUTLET FITTING WILL HAVE TO
BE CLOSED DURING MAINTENANCE WORK AND WHEN CHANGING THE
FILTERING CARTRIDGES, SO THAT WATER CANNOT ESCAPE.
E. INSTALL A TAP WITH A ¾" MALE FITTING (STANDARD CONNECTION FOR
WASHING MACHINES AND DISHWASHERS) ON THE MAINS WATER PIPE TO
SUPPLY PURA PLUS™. ALTERNATIVELY YOU CAN USE THE ½" SUPPLIED
CONNECTION (COD. 2ZPUA0002; SEE CHAPTER ACCESSORIES), WITH ON TAP.
F. INSTALL A WATER DRAIN LINE FOR THE WASTE WATER PRODUCED BY PURA
PLUS™. IF NECESSARY, USE THE COLLAR SUPPLIED WITH THE INSTRUMENT,
(Code SPUA035) THAT SHOULD BE INSTALLED ON THE SINK TRAP.
NOTE 1: PURA PLUS™ can be installed with the filters facing upwards, resting on the
metal bracket equipped with feet, or hanging on the wall with the filters facing
downwards or upwards, and fixed by means of the holes in the bracket.
NOTE 2: Make sure the low level led of the clean water tank of the autoclave is on; if it
is not, discharge the water from the tap on the rear panel of the autoclave (see manual
for use of the autoclave).
10