Adjusting The Temperature-Based Cooling Cycle (P1); Adjusting The Time-Based Cooling Cycle (P2); Gelato Retain Time (P4) (Only Models Vb90, Vb120, Vb160) (Only With Time-Based Cycle Production) - Stoelting VB 35 Manuel D'utilisation Et Entretien

DURING ITS FACTORY INSPECTION, THE MACHINE HAS BEEN PROGRAMMED WITH OPTIMAL
TIME AND TEMPERATURE PARAMETER VALUES FOR THE OPERATION CYCLES.
DO NOT CHANGE PROGRAMMING UNLESS IT IS STRICTLY NECESSARY.
IF PARAMETER VALUES DO NEED TO BE ALTERED, MAKE ANY NECESSARY MACHINE PROGRAM-
MING CHANGES.
The machine prepares itself to operate and subsequently the
tank temperature is displayed on the digital display (2).
onds to access the programming functions.
The functions are divided into four clearly separate categories
quence on the machine digital display.
P1 Adjusting the temperature-based cycle
P2 Adjusting the time-based cycle
P3 Machine operating time
P4 Gelato retain time (only models VB90, VB120, VB160)
H-0 Machine operating time (thousands "H-0"expressed in hours)
000 Machine operating time (Hundreds, tens, units "000" expressed in hours)
THE SWITCH BETWEEN FUNCTIONS OCCURS AUTOMATICALLY WITH A TIME INTERVAL OF 5 SEC-
ONDS. TO ACCESS THE FUNCTION TO ADJUST THE OPERATOR MUST WAIT FOR THE DISPLAY TO
SHOW THE CODE ASSOCIATED TO THE DESIRED FUNCTION.
AT THE END OF THE PROGRAMMING CYCLE THE SYSTEM EXITS THE FUNCTIONS AUTOMATICALLY
AND THE CYLINDER TEMPERATURE IS SHOWN ON THE DIGITAL DISPLAY.
28
2
1
-
A
B
-
2
1
A
B