Sample Numbering; Identification Of Sample Location - MACHEREY-NAGEL PF-12 Plus Manuel

To create and manage user defined methods one can also use the free-of-charge
NANOCOLOR ® data export software from MACHEREY-NAGEL. This can be downloaded
via www.mn-net.com/PF-12Plus. Further information can be found in the software manuals
under the same link.

7.2 Sample numbering

To differentiate between samples, the PF-12
ment (starting with 0001). Subsequent measurements are numbered accordingly. You have
the option to change the sample number after every measurement and to assign it to the
current result. To do so, press
enter the 4 digit sample number via the keypad. Once you have entered the sample number,
it is displayed together with all other sample information at the bottom of the display. The
following measurements are then automatically numbered. The sample numbering is carried
out on the basis of a daily counter. With each new day the PF-12
sample number 0001 and counts upwards for each further measurement.

7.3 Identification of sample location

To differentiate between sampling locations, you have the option to enter a sample location
after performing a measurement (up to 12 characters). Press button
option for the sample location. Once you have entered the sample location, it is displayed
together with all other sample information at the bottom of the display. The sample location
is added to the result in the memory automatically. If you have entered additional sample
locations before, you can press
20 previously defined sample locations with the buttons
es choose the appropriate entry with the
the keypad. Deleting single digits can be accomplished by typing the button "1" two times.
44
before the next measurement. An entry option appears to
to choose or edit the sample location from a list of up to
09.12.2014
Plus assigns a sample number to every measure-
/
/ buttons and replace the existing letters with
Plus starts to count with the
to open the entry
. For editing the sample plac-