LG WKEX200H A Série Manuel D'installation page 83

Problem
Steam is not visible This is normal.
during Steam cycle.
• Steam vapor is difficult to see when the door is closed. However, condensation will
Drum does not turn This is normal.
during Steam cycle.
• The drum is turned off so that the steam vapor remains in the drum. The drum will
Cannot see steam This is normal.
vapor at the
• Steam is released at different stages of the cycle for each option.
beginning of cycle.
Indicator Messages
Problem
Flow Sense indicator Exhaust system is too long or has too many turns/restrictions.
W
( ) shows four bars
• Install a shorter or straighter duct run. See the Installation Instructions for details.
during the drying
Partial blockage of the ductwork due to lint buildup or other foreign object.
cycle or the display
d8O
shows after
• Ductwork should be checked/cleaned immediately. Dryer can be used in this condition, but
drying.
The appliance has detected a restriction in the external dryer venting.
• If exhaust restrictions are sensed by the Flow Sense system, the indicator will remain on
• This warning light is not a dryer failure and is not covered by the dryer warranty. Contact a
The Flow Sense After clearing the restriction, the Flow Sense system requires multiple, consecutive
W
cycles to determine that the performance value has improved before the Flow Sense
indicator ( )
indicator is reset.
remains active after
clearing the
• If the Flow Sense indicator remains active for more than five cycles after the restriction has
restriction in the
venting.
Check filter indicator Lint filter not cleaned properly.
K
( ) is on during the
• Remove the lint from the filter before every load. With the lint removed, hold the filter up
drying cycle.
normally form on the inside of the dryer door if the steam system is operating normally.
normally turn for about 2 seconds once a minute.
drying times will be longer and energy consumption will increase.
for 2 hours after the end of the cycle. Opening the door or pressing the Power button will
turn off the display.
duct cleaning service to set up an appointment to have your exhaust system cleaned and
inspected.
been cleared, call for service.
to a light to see if it is dirty or clogged. If it looks dirty, follow the cleaning instructions.
With some loads that produce high amounts of lint, it may be necessary to clean the filter
during the cycle.
Possible Cause & Solution
Possible Cause & Solution
TROUBLESHOOTING 55