Important Safety Instructions; Supported Monitor Settings; Connecting The Monitor - Medion MD 30217PS Mode D'emploi

Important Safety Instructions

Tip: Read the detailed instructions on the digital media, which accompany the equipment.
• Never open the housing of the TFT monitor! When the housing is open there is a danger of injury from electric shock!
• Do not insert any objects through the slots and openings of the monitor. This may lead to an electrical short-circuit or
even fire resulting in damage to your TFT monitor.
• Slots and openings in the TFT monitor are for ventilation purpose. Do not cover these openings, as this may lead to
overheating.
• Do not allow children to play unattended with electrical equipment. Children may not always correctly recognize
danger.
• An injury hazard exists when the display breaks. Wear protective gloves to pack the broken parts and send them into
your service center for proper disposal. Then wash your hands with soap, because it is possible for chemicals to escape.
• Never exert pressure on the display. This could break the monitor.
• Do not touch the display with your fingers or with sharp objects to avoid damage.
• After transporting your TFT monitor please wait until it has assumed the ambient temperature before connecting and
switching it on. Extremely high variations in the temperature or humidity may result in condensation forming on the
inside of the TFT monitor which could cause an electrical short-circuit.
• This monitor compiles with the regulation ISO 13406-2 class II (Class of pixel failures).
Start-Up
P Y C
REPARE OUR OMPUTER
If you have previously used your computer with a CRT monitor, you will need to make sure that your computer's display
settings are supported by your TFT monitor. The following pages describe how to verify and change your display settings.
S M S
UPPORTED ONITOR
recommended resolution (physical)
Caution! If your display settings exceed the capabilities of your monitor, your monitor may show only a
blank display.
• Operate your TFT monitor only with grounded outlets with AC 100-240V~/ 50-60 Hz. If you are not sure about the power supply
at your location, check with your power company.
• Use only the power connection cable provided.
• For additional safety we recommend use of a surge protector to protect your TFT monitor from damage resulting from
voltage surges or lightning.
• To remove the TFT monitor from the power supply, disconnect the plug from the AC outlet.
• The power outlet must be in the vicinity of your TFT monitor and within reach of the power cables. DO NOT stretch the
power cables tightly to reach a power outlet.
• You should arrange the TFT monitor cables in a manner that no one can trip over or step on them.
• To avoid damage of cable do not place any objects or furniture on the cable.

Connecting the Monitor

1. Ensure that the TFT monitor is not yet plugged in and neither the TFT monitor nor the computer is switched on.
2. Prepare your computer for the TFT monitor if necessary with the correct settings for your TFT.
ETTINGS
SXGA Resolution
I I
M M P P O O R R T T A A N N T T
1280 x 1024 @ 60 Hz*
S S I I
A A F F E E T T Y Y N N S S T T R R U U C C T T I I O O N N S S
1