Dab Operation; Automatic Tuning - Roadstar HIF-1999D+BT Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
in stereo.
Press the MENU BUTTON (19) until select "AUDIO SETTING", then
press the TUNING/ENTER KNOB (21) and turn again the TUNING/
ENTER KNOB (21) to select between FORCED MONO or STEREO
ALLOWED.

DAB OPERATION

1. Press sequencially the FUNCTION BUTTON (6) to select DAB mode.
2. Extend the DAB antenna at the back of the unit.

AUTOMATIC TUNING

1. Press the MENU BUTTON (19), then move the TUNING/ENTER
KNOB (21) to select FULL SCAN.
2. Press the TUNING/ENTER KNOB (21) to start searching the DAB /
DAB+ station.
MANUAL TUNING
1. Press the MENU BUTTON (19), then move the TUNING/ENTER
KNOB (21) to select MANUAL TUNE.
2. Turn the TUNING/ENTER KNOB (21) to tune manually the desired
station.
3. When tuned a DAB stereo station, the "stereo" will show on the LCD.
4. During DAB reception, press the INFO BUTTON (31) to see the infor-
mation of the playing DAB station on the display, i.e Program Type /
Program No. / Frenquency Range / Signal Strength / Time / Date.
PRESET MEMORY DAB / DAB+
1. When selected the desired station, press and hold the PRESET BUT-
TON (33) for 2 seconds.
2. The display show "Preset Store 1: (Empty)". Turn the TUNING/ENTER
KNOB (21) to select the desired preset number, then press the
TUNING/ENTER KNOB (21) to store the station.
English
7
8
English
TURNTABLE OPERATION
VERY IMPORTANT!
To prevent damages from transportation, a
transit screw is located at the upper right side
of the turntable platform. Before start playing,
use a screwdriver and turn the transit screw
in clockwise direction (screw going down)
completely. In case of transportation, remember to clock again this screw
in counter-clockwise direction to prevent damages.
Lock Lever
Stylus Cover
Preparation
1. Open the Record Player Cover.
2. Release the Tonearm Clamp, and remove the stylus protector.
Listening to Records
1. Press the FUNCTION BUTTON (6) to select the TURNTABLE fun-
ction.
2. Place a record on the turntable, over the central spindle. Place the EP
adapter over the central spindle when playing 17cm EP records.
3. Set the Speed Selector (24) to 33/78 or 45 rpm according to the re-
cord.
4. Release the tonearm clamp, and remove the protective cap from the
stylus.
5. Lift the Tonearm with the Tonearm Lift Lever.
6. Move the tonearm to the beginning of the record, or to the start of a
particular track.
TRANSIT
SCREW

Publicité

Table des Matières
loading

Table des Matières