Cleaning And Maintenance; Generalities And Products For Cleaning; Removing The Food - Saddle; Removing The Blade Cover - Diamond 275/TE Mode D'emploi

5) CLEANING AND MAINTENANCE OPERATIONS

5.1 GENERALITIES AND PRODUCTS FOR CLEANING

Before carrying out any cleaning or maintenance operations, check to make sure that the mains
switch be off and the supply plug disconnected from the mains.
Accurately clean the equipment every day for a correct operation and life of the equipment.
Despite the several safeties, take great care to avoid cutting risks when using the blade.
Clean the equipment with the usual neutral detergents which must not contain soda or alcool.
When cleaning removed elements, do not use a dish washer for not damaging anodized parts.
5.2 REMOVAL OF THE FOOD SADDLE WITH RELEASING DEVICE).
1. Set the knob on "0" position for slice thickness adjustment
2. Set the saddle opposite to the blade as shown in figure fig.8
3. Turn the knob of the unblocking device fig.9
4. Loosen the knob fixing the saddle and remove the saddle.fig.10
Clean the saddle with a water jet. Reverse these operations for reassembling the saddle.
5.3 REMOVAL OF THE BLADE-COVER
1. Loosen the knob opposite to the blade
2. Push the knob towards the blade and release the blade cover from its housing. Fig.11
3. Remove the blade-cover from the slicer. Fig.12
Clean the blade-cover with a water jet.
5.4 CLEANING THE BLADE AND RING – STOP SLICES
Cleaning the blade and ring is a dangerous operation, hence, take great care to prevent any
possibility of cutting.
For their cleaning never use a water jet, but use a damp cloth and detergents, then rinse and dry with a cloth.
For the cleaning, use non-toxic products which guarantee the perfect hygiene.
Clean carefully the blade edge and the inside of the ring.
1. Use a damp cloth to clean the opening between the blade and ring. fig.13
2. Rotate manually the blade and clean using the damp cloth. fig.14
3. If necessary turn off the two screw to take off the stop slices for the cleaning of the part and the bottom of
the blade. fig.15
For the machine reassembly, reverse all the above mentioned operations.

5.5 POWER CORD CHANGE

For the power cord change it is necessary to apply to technical assistance.
12