Safety; You Should Pay Attention To This - Kollmorgen PCMM AKC-PCM-Mx Mode D'emploi

PCMM Installation Manual | 1 English

1.2 Safety

1.2.1 You should pay attention to this

Specialist staff required!
Only properly qualified personnel are permitted to perform such tasks as transport, assembly,
setup and maintenance. Qualified specialist staff are persons who are familiar with the trans-
port, installation, assembly, commissioning and operation of PCMM and who bring their rel-
evant minimum qualifications to bear on their duties:
Transport: only by personnel with knowledge of handling electrostatic sensitive com-
ponents.
Unpacking: only by electrically qualified personnel.
Installation: only by electrically qualified personnel.
Basic tests / Setup: only by qualified personnel with knowledge of electrical engineering
and motion control technology
The qualified personnel must know and observe ISO 12100 / IEC 60364 / IEC 60664 and
national accident prevention regulations.
Read the documentation!
Read the available documentation before installation and commissioning. Improper handling
of the device can cause harm to people or damage to property. The operator of systems using
the PCMM must ensure that all personnel who work with the motion system read and under-
stand the manual before using the system.
Check Hardware Revision!
Check the Hardware Revision Number of the product (see product label). This number is the
link between your product and the manual, it must match the Hardware Revision Number on
the cover page of the manual.
Pay attention to the technical data!
Adhere to the technical data and the specifications on connection conditions (rating plate and
documentation). If permissible voltage values or current values are exceeded, the PCMM
can be damaged.
Perform a risk assessment!
The manufacturer of the machine must generate a risk assessment for the machine, and take
appropriate measures to ensure that unforeseen movements cannot cause injury or damage
to any person or property. Additional requirements on specialist staff may also result from the
risk assessment.
Observe electrostatic sensitive components!
The PCMM contain electrostatic sensitive components which may be damaged by incorrect
handling. Electrostatic discharge your body before touching the PCMM. Avoid contact with
highly insulating materials (artificial fabrics, plastic film etc.). Place the PCMM on a con-
ductive surface.
Never modify the products!
It is not allowed to modify the PCMM without permission by the manufacturer. Opening the
housing causes loss of warranty.
6 Kollmorgen | kdn.kollmorgen.com | February 2018