Designated Use - SKS Sweden BONFIGLIOLI Vectron ACTIVE CUBE Guide De Démarrage Rapide

WARNING
• Do not touch the heat sink of the frequency inverter during operation. Danger of burns due to
high surface temperatures.
• Do not remove any covers of the frequency inverter during operation.
• Please note that Bonfiglioli Vectron GmbH will not accept any responsibility for compatibility with
third-party products (e.g. motors, cables, filters, etc.). If you use the device in combination with
third-party products, you do so at your own risk.
• The earth leakage current of the inverter can be greater than AC 3.5 mA or DC 10 mA.
• According to EN61800-5-1 please note: This product can cause a direct current in the protective
earth conductor. When a residual current device (RCD) or a residual current monitor (RCM) is
GB
used for protection in the event of direct or indirect contact, only an RCD or RCM of Type B is
permissible on the power supply side of this product.
Never touch electronic components or terminals.
•
Do not commission any damaged components.
•
• Any repair work may only be carried out by the manufacturer or persons approved/licensed by
the manufacturer.
• Any repair work must be carried out by qualified electricians.
• Except for modifications described in this document, the frequency inverter must not be changed
in any way.
• Do not connect unsuitable voltage sources.
• Keep the instructions accessible to the user.
NOTE
The frequency inverter may be connected to power supply every 60 s.
This must be considered when operating a mains contactor in jog operation mode. For commission-
ing or after an emergency stop, a non-recurrent, direct restart is permissible.
NOTE
For more information about the range of functions of the frequency inverter and about operation,
maintenance and storage, refer to the co-applicable Operating Instructions.
1.2

Designated use

The product is a frequency inverter. It is designed for
• Installation in machines and electrical equipment
• Industrial environments
The frequency inverters are electrical drive components intended for installation in industrial plants or machines.
Commissioning and start of operation is not allowed until it has been verified that the machine meets the require-
ments of the EC Machinery Directive 2006/42/EC and DIN EN 60204-1.
The frequency inverters meet the requirements of the low voltage directive 2006/95/EEC and DIN EN 61800-5-1.
CE-labeling is based on these standards. Responsibility for compliance with the EMC Directive 2004/108/EC lies
with the operator.
Frequency inverters are only available at specialized dealers and are exclusively intended for commercial use as per
EN 61000-3-2.
No capacitive loads may be connected to the frequency inverter.
46
Quick Start Guide ACU
02/15