Simoniz S2000 Guide D'utilisation page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

HOW TO APPLY
DETERGENT/CLEANING
SOLVENTS
Applying detergent or cleaning
solvents is a low pressure operation.
NOTE: Use only detergent/cleaning
solvents designed for pressure washer
use. Do not use bleach.
To Apply detergent/cleaning solvent:
1.
Press detergent
hose onto barbed
fitting located
near high
pressure hose
connection of
pump as shown
in Fig 8.
2.
Place other end of detergent hose
with filter on it into container
holding detergent/cleaning solution.
NOTE: For every 7 gallons of water
pumped, 1 gallon of
detergent/cleaning solution will be
used.
3.
Set multi-adjustable nozzle to low
pressure setting. See How To Use
Wand paragraph in this section.
4.
After use of detergent/cleaning
solvents, place detergent hose into
container of clean water and draw
clean water through detergent
injection system to rinse system
thoroughly. If detergent/cleaning
solvents remain in the pump it
could be damaged. Pumps
damaged due to detergent/cleaning
solvents will not be covered under
warranty.
NOTE: detergent/cleaning solvents will
not siphon when spray wand is in the
high pressure setting.
A04196
Fig. 8
Barbed
Fitting
10- ENG
STARTING
Prior to starting, refer to your Engine
Manual for proper starting
procedures.
1.
In a well ventilated, outdoor area
add fresh, high-quality, unleaded
gasoline with a pump octane
rating of 86 or higher. Do not
overfill. Wipe up spilled fuel before
starting the engine. Refer to
Engine Owner's Manual for correct
procedure.
2.
Check engine oil level. See
Engine Owner's Manual for correct
procedure.
3.
Verify the filter
screen is in
water inlet of
pump (see Fig.
9).
4.
Connect water
source to pump
inlet (see Fig. 10). NOTE: Water
source must provide a minimum of 5
gallons per minute at 20 PSI.
5.
Connect high pressure hose to
pump outlet.
Fig. 10
Water Supply
6.
If applying a detergent or
cleaning solvent, see How To
Apply Detergents/Cleaning
Solvents instructions in this
section.
7.
Turn water supply on.
NOTE: Failure to do so could
cause damage to the pump.
Fig. 9
Filter Screen
High Pressure Hose

Publicité

Chapitres

Table des Matières
loading

Table des Matières