GE JGP628 Instructions D'installation page 5

InSTALLInG THe CooKToP unIT
1 LoCATe eLeCTrICAL ouTLeT AnD
GAS SHuT-off vALve BeneATH
CABIneT
NEVER REUSE OLD
CONNECTORS WHEN
INSTALLING THIS
UNIT.
Install a manual shut-off valve in the gas line in an
easily accessible location outside the cooktop. Be
sure you know how and where to shut off the gas
supply to the cooktop. Install the electrical outlet
12" below the countertop.
2 ProTeCT SurfACe of CooKToP
Place a towel or tablecloth onto the
countertop. Lay the cooktop upside down onto the
protected surface.
Bottom of cooktop
Cloth under Cooktop
3 ATTACH foAM TAPe
(glass maintop models only)
Apply the foam tape around the outer edge
of the glass. Do not overlap the foam tapes.
Bottom of Cooktop
Cooktop Glass
Installation Instructions
Shut-Off
Electrical
Valve
Outlet 12"
Below
Countertop
Foam Tapes
LoCATe MounTInG PArTS
4
Remove the hold down brackets from the
literature package.
ATTACH BrACKeTS To CooKToP
5
Remove the screw from the bottom of the
cooktop and screw the hold-down bracket
to the side of the cooktop unit. Repeat for opposite
side of cooktop.
Bottom
of Cooktop
Cooktop
Glass
InSerT CooKToP InTo CuTouT
6
Insert the cooktop centered into the cutout
opening. Make sure the front edge of the countertop
is parallel to the cooktop. Make final check that all
required clearances are met.
Once the unit is in place, screw the hold- down
bracket into the cabinet sides to secure the unit
into place.
5
Pre-drilled
hole
Foam Tapes
Cooktop