GE JGP628 Instructions D'installation

Installation
Instructions
36" Sealed Gas Cooktop
JGP628, JGP630, JGP963, JGP970,
JGP975, ZGU36
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com
In Canada, call 1.800.561.3344 or Visit our Website at: www.geappliances.ca
IN THE COMMONWEALTH OF
MASSACHUSETTS:
¢ This product must be installed by a licensed
plumber or gas fitter.
e When using ball-type gas shut-off valves, they
shall be the T-handle type.
¢ A flexible gas connector, when used, must not
exceed 3 feet.
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
> IM PO RTANT — save these instructions
for local inspector's use.
¢ IMPORTANT — observe al governing
codes and ordinances.
¢ Note to Installer - Be sure to leave these
instructions with the Consumer.
e Note to Consumer - Keep these instructions for
future reference.
e Product failure due to improper installation is not
covered under the Warranty.
A WARNING - tris appliance must be
properly grounded.
« IMPORTANT — teak testing of the
appliance shall be conducted according to the
manufacturer's instructions.
e Proper installation is the responsibility
of the installer and product failure due to
improper installation is NOT covered under
warranty.
FOR YOUR SAFETY:
AWARNING — lf the information
in this manual is not followed exactly, a fire,
explosion or gas leak may result causing property
damage, personal injury or death.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other
appliance!
WHAT TO DO IF YOU SMELL
GAS:
¢ Do not try to light any appliance. Do not touch
any electrical switch; do not use any phone in
your building.
e Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
e¢ If you cannot reach your gas supplier, call the fire
department.
Installation and service must be performed by
a qualified installer, service agency or the gas
supplier.
A WARNING — Disconnect all electrical
power at the main circuit breaker
or fuse box before installing.
31-10612-4 (10-10 GE)
This cooktop has been design certified
by CSA International. You'll find safety precautions
in your Owner's Manual.
Read them carefully.
e Installation of this cooktop must conform with
iocal codes or, in the absence of local codes with
the National Fuel Gas Code, ANSI Z223.1/NFPA
54-Latest edition.
e Be sure your cooktop is installed properly by a
qualified installer or service technician.
¢ To eliminate reaching over surface burners,
cabinet storage above burner should be avoided.
¢ Do not install the unit near an outside door or
where a draft may affect its use.