GE JGP628 Instructions D'installation page 15

CHAnGe CooKToP Burner
3
orIfICeS (ConT.)
D Locate the LP/Propane orifices shipped
inside the literature package. They
will have a digit number and the letter "L" on
the side. (Important: Save the orifices
removed from the appliance
for future use.)
Each orifice will show a series of engraved
marks, (I, II, III, X or none),
located on the top.
These marks denote the precise location of each
orifice to the cooktop burner.
I II
I II
18,000 BTu/Hr Burner
(on some models)
The 18,000 BTU/HR burner has two orifices with
markings located in the sides only. (See rating
plate on bottom of appliance).
noTe: The main orifice is located low in the center
of the burner while the simmer orifice is located
higher behind the center of the burner.
Simmer
orifice
Installation Instructions
III
X
III
X
Main orifice
15
units with 4 burners
units with 5 burners
Left front
Model orifice
JGP630 II
JGP963 III
JGP970
ZGU36K
JGP975 III
Install the LP/Propane orifices in their precise
e
locations as noted in the illustrations above.
Return the natural gas orifices to the bracket
f
and reattach the bracket and
the instruction sheet to the pressure regulator
using the screw removed previously.
G Replace the burner bases, heads, caps and
top grates. (noTe: When re-attaching the
burner bases to glass top units, tighten screws
to a maximum of
10 in.-lbs torque.)
right front
orifice
III
X
Replace: With:
206X N ➜ 108X L
Main
➜ 34L
Simmer 57N