GE JGP628 Instructions D'installation page 14

MAKInG THe LP ConverSIon
3 CHAnGe CooKToP Burner
orIfICeS
Remove the top grates,
A
burner caps, and burner
heads.
Remove the spark
B
igniters from the burner
base (if required to
access the orifices).
Using a No. 15 "Torx"
head driver bit, remove
the screws holding the
burner base in position.
Using a 7mm nut driver,
C
remove the top burner
orifices. These may be
accessed through the
hole in the cooktop.
Installation Instructions
(ConT.)
Remove This
Assembly
Orifice Spud Located
Through This Opening
Burner cap
Burner
head
Burner
base
Spark igniter
18,000 BTU Burner
(on some models)
Burner
cap
Burner
head
Burner
base
Spark igniter
14
CHAnGe CooKToP Burner
3
orIfICeS (ConT.)
NOTE: On most burners,
the orifices have a spring-
loaded retaining ring around
the hex head to hold the
orifice in the nut driver during
installation and removal. A
slight amount of force is required to push the nut
driver down over the ring.
Retainer
Ring