Turntable Operation - Crosley C100BT Manuel D'utilisation

English

Turntable Operation

1. Turn the Power Knob clockwise to turn on the power.
2. Set the Speed Switch accordingly
Note: When 33 RPM is selected the Speed Switch LED will be red. When 45 RPM is selected
the Speed Switch LED will be green.
3. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
4. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place whenever
the turntable is being moved or cleaned.
5. Press the Start/Stop Button to start the turntable platter's rotation.
6. Release the tonearm Hold Down Clip.
Note: when the turntable is not in use, remember to lock back hold down clip.
7. Use the Cue Lever to lift up the tonearm.
8. Gently move the tonearm over the record where play is desired to begin. Set the
Cue Lever back to the down position, the tonearm will descend slowly onto the
record and begin to playback.
9. When the record is finished playing, use the Cue Lever again to raise the tonearm
and then return it to the Tonearm Rest. Release the lever to let the tonearm sit
back at its rest. To suspend the playback, repeat the same steps.
10. Lock the Hold Down Clip to secure the tonearm.
11. Press the Start/Stop Button again to stop the turntable platter's rotation. Turn the
Power Knob counter-clockwise to turn off the power.
Anti-skate Adjustment
• A small outward "anti-skating" force can be applied to the tone arm to compensate
for the "skating" force that pulls the arm toward the center of the record.
• For best performance during normal turntable usage, it is recommended to set the
anti-skate control knob to the same value as indicated by the downforce scale dial.
7