Turntable Operation - Crosley CR1704A-WM Manuel D'utilisation

Auxiliary (AUX) Audio Operation
RCA input is located on the REAR CONTROL PANEL and can accept a variety of
device inputs. No input cord is supplied with the jukebox. The user-supplied cable
should match the output of the device attached to the jukebox and have an "RCA"
connection for input and connection with the jukebox. Ensure the audio device
connected to the AUX connection has a proper volume adjustment for output.

Turntable Operation

1. 45 RPM Adapter
2. Tonearm Lift Lever
3. Speed Switch
4. Auto Stop Switch
5. Hold Down Clip
6. Tonearm Rest
1. Press the INPUT
button on the front panel or on the remote to select the Phono Mode.
2. Set the Speed Switch accordingly.
3. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
4. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place whenever
the turntable is being moved or cleaned.
5. Release the tonearm Hold Down Clip.
Note: when the turntable is not in use, remember to lock back hold down clip.
6. Use the Tonearm Lever to lift up the tonearm.
7. Gently move the tonearm over the record where play is desired to begin. Set the
Tonearm Lever back to the down position, the tonearm will descend slowly onto
the record and begin to playback.
8. When the record is finished playing, use the Tonearm Lever again to raise the
tonearm and then return it to the Tonearm Rest. Release the lever to let the
tonearm sit back at its rest. To suspend the playback, repeat the same steps.
9. Lock the Tonearm Clip to secure the tonearm.
8