Turntable Operation; Usb Recording - Crosley CR6232A Manuel D'instructions

English

Turntable Operation

1. Rotate the On/Off Volume Knob to turn on the power.
2. Set the Speed Switch accordingly.
3. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
4. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place
whenever the turntable is being moved or cleaned.
5. Release the tonearm Hold Down Clip.
Note: when the turntable is not in use, remember to lock back hold down clip.
6. Lift up the tonearm and move it over the record where play is desired to begin.
Gently put down the tonearm and begin the playback.
7. When the record is finished playing, gently lift up the tone arm and move it
back to the tonearm rest.
8. Lock the Tonearm Clip to secure the tonearm.
Platter Auto-stop
If the Auto-stop Switch is set to ON position, the platter will stop spinning
automatically when the record plays to the end. In some rare occasion, if the
turntable stops playing before the end of the record, set the switch to OFF
position the turntable should overcome this issue.

USB Recording

To record the vinyl into digital file formats such as MP3, you can use the USB
Output Jack to connect this unit to your computer's USB port and use the
software Audacity.
1. Install the recording software Audacity (comes along with the product CD) to
your computer.
2. Use the supplied USB cable to connect the unit to your computer.
3. Turn on the power of the unit.
4. Run the program Audacity.
Audacity is free software, distributed under the GNU General Public License (GPL). For
most updated version of Audacity and instructions on how to use it, please visit Audacity
website: http://www.audacityteam.org/
6