Clatronic KA 2567 DS Mode D'emploi page 26

42834-05-KA 2567 DS NEU
Electrical Connection
GB
• Make sure that the appliance is switched off (operating switch on „OFF/0"). The
LED is off.
• Before inserting the plug in the socket make sure that the mains voltage to be
used matches that of the device. For details see the machine label.
• Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
1. Pull the lid of the water tank forwards. Fill the machine to the level corresponding
to the number of cups required with cold water.
The white rod in the water tank rises with the water level. The water level can be
read off at the bottom end using the printed figures.
2. Place a paper filter (size 1 x 4) into the filter funnel and fill it with coffee powder
(approx. 1 teaspoon for 2 cups).
3. Place the can on the hotplate. Make sure that the can is directly under the filter
so that the filter's drip-stop lever can be duly opened!
4. Close the water tank lid.
5. Move the switch to the "EIN/1" position. The control lamp of the switch is on. The
coffee takes approximately 10 - 15 minutes to boil. When no more coffee is run-
ning into the pot it can be removed.
If you would like to keep the remaining coffee warm, the switch must remain in
the "EIN/1" position. The hot plate will keep the coffee warm until you switch the
machine "AUS/0".
Switching Off
The machine is switched off when the switch is in the "AUS/0" position.
Descaling is necessary when the time needed to prepare coffee becomes consider-
ably longer.
Only commercially available descaling products based on citric acid should be
used.
Before cleaning the machine you should always remove the mains lead and wait
until the machine has cooled down. The machine should only be cleaned with a
slightly damp cloth. Do not use any strong detergents or solvents for cleaning. The
coffee pot and the filter pad should be cleaned by rinsing in cold water.
26
22.07.2003 10:41 Uhr
Operation
Descaling
Cleaning
Seite 26