Bimar DL15 TURBO&TIMER Notice D'instructions page 16

Warning: the heater must be used only if its feet are
correctly assembled.
To use the appliance, the two feet provided must be
assembled and locked tight with the screws provided.
 Before connecting the heater check that the voltage shown on the specifications
plate corresponds to that of the electrical supply, and that the plug is effectively
grounded. In the event of incompatibility between the power supply and the
plug, have the plug replaced with a suitable model by a qualified professional,
who should ensure that the size of the cable is suitable for the power used by
the unit. The use of adaptors or extensions is generally not advisable; if it is
necessary to use them, they must comply with safety regulations and the total
current (amps) must not be rated lower than the maximum current of the the
appliance.
 Place the convection heater far from any other source of heat, from flammable
material (curtains, tapestries, etc.), from flammable gases or flammable material
(spray cans) and from materials that can be deformed by heat. Make sure there
is 100cm of free space in front of the heater and 30cm free space on both sides
and at the back (at the portable installation).
 The surface must be stable, not sloping (as the unit may fall over), heat resistant.
 Ensure that the power cable is correctly positioned and does not come into
contact with hot parts or sharp edges, nor become wound around the
appliance itself, is not twisted and does not snag, in order to prevent the
appliance from falling. Make sure there's no risk of tripping, to prevent people
from accidentally tripping over it or being injured.
 Make sure that the air inlet and outlet are not blocked, to prevent fire hazards
or possible overheating; do not cover the device, nor use it for drying laundry.
 If there is a fault or the appliance is not working correctly, switch it off and
have it checked by a qualified professional. Repairs done by an unqualified
person can be dangerous and cause the guarantee to become void.
USE
Note: before assembling the appliance, ensure that it is not plugged into the mains.
First use
Warning:run the appliance for at least a few hours to eliminate the "new smell" and
any oil residue from the manufacturing process.During this operation, ventilate the
room well to eliminate the "new smell" that is given off.
Model with switches and with room thermostat regulation (type HC504&.CH)
The heater is equipped with the following adjustment devices:
Switch (A) to turn on the fan (turbo function), turns on in pos.(
-
pos.(●).
Switch (B) to adjust the power 750W = heat with low power consumption, turns on
-
in pos. (750) or turns off in pos.(●).
16
) or turns off in