Battery Check - Olympus CAMEDIA D-560ZOOM Manuel De Base

Memory gauge
The memory gauge lights up when you take a picture or record a movie. While
the gauge is lit, the camera is storing the picture or the movie on the card.
The memory gauge indication changes as shown below depending on the
shooting status.
If the memory gauge is fully lit, wait a few seconds until it goes off to take the
next shot.
When taking still pictures
Before shooting
(Gauge is off)
En
When recording movies
Shoot
Before shooting
(Gauge is off)

Battery check

If the remaining battery power is low, the battery check indication on the
monitor changes as follows while the camera is turned on.
Lit (Green)
(The indicator turns
off after a while.)
Remaining power
level: high
8 En
Shoot
One picture
taken
(Lit)
If you continue shooting
Wait
During shooting (Lit)
• Shooting is not possible until the lit area goes off
completely.
• Movie recording ends automatically when the memory
gauge is full.
Blinks (Red)
Remaining power level: low
Prepare new batteries.
Shoot
More than
two taken
(Lit)
Remaining power level:
exhausted.
Replace with a new batteries.
Shoot
Wait
No more pictures can
be taken (Fully lit).
Wait until the gauge
returns to the status
on the left to take the
next shot.
No indication
Green lamp and orange
lamp on the right of the
viewfinder blink.