Frequently Asked Questions - Bestway Inflate YourFun FAST SET Série Manuel D'instructions

1. What is a suitable base for the Fast Set pool?
Almost any completely flat, solid, level surface can be used. Do not use sand as a leveling material as it is prone to shifting under the pool. The ground should
be dug out until it is perfectly level. Do not set up on driveways, decks, platforms, gravel or asphalt. The ground should be firm enough to withstand the weight and
pressure of the water: mud, sand, soft / loose solid or tar are not suitable. A concrete base can be used but care should be taken not to drag the pool across the
surface as abrasions could tear the liner. If the pool is to be set up on a lawn, it is recommended that the grass is removed from where the pool will sit as it will die
and may cause odors / slime. Certain types of hardy grass can grow through the liner as can aggressive bushes / plants by the side of the pool. Ensure adjacent
vegetation is cut back where necessary. Use of a ground cloth assists in protecting the base of the pool.
2. How will I know if my pool is set up on unleveled ground?
If your pool appears to be bulging on one side it is not set up on level ground. It is important that you empty your pool and move the pool to a level site. If the
pool is not on level ground it will place undue stress on the seams and could result in the seams bursting which will cause flooding, property damage and
potentially personal injury or death.
Fill your pool following the instructions in the owner's manual carefully. This will ensure that you do not waste water and the pool can be moved easily so that
the ground can be leveled at an appropriate time and not after you have completely filled it with water.
3. How much pressure is recommended to use during inflation of the ring of my Fast Set pool?
We recommend the use of a Bestway inflation Pump (not included) or other low-pressure pump when attempting to inflate the top ring. The top ring is filled to
capacity when it becomes round in shape and is firm to the touch. Pay attention to major air temperature variation. An over inflated ring heated by the sun may
burst or could lead to leaks in the seam; if the ring feels too firm let some of the air out. In cold ambient temperature the top ring will lose some pressure, it may
appear as though the ring is deflating due to a leak, DO NOT add air since the air inside will expand again once the temperature rises. Note: Every use of air
compressor or high pressure pump for the inflation of the ring is forbidden. Bestway inflatables will not be responsible for bursting of the ring due to the use of air
compressor.
4. Can I have my pool filled by a water service?
We recommend using a garden hose under low pressure for filling your pool. If it is necessary to use a water delivery service, it is best to fill the pool with one
inch of water by hose and smooth wrinkles first. Use a water service that is able to regulate the flow of water to prevent damage. Ensure you stop at each step as
noted in the instruction manual to ensure your pool is level. Bestway will not be held responsible for pools damaged or weakened by water delivery services.
5. What is the maximum fill height of the pool?
Fill pool until water capacity is 80% up to the bottom of the inflated ring of the pool. Never attempt to fill your pool beyond the base of the ring. We recommend
leaving extra room to account for water displacement when occupants are inside the pool. You may have to top up the water during the season which has been
lost through evaporation or normal use.
6. My pool is leaking, what do I do to fix it?
The pool does not need to be emptied to fix any holes. Self-adhesive underwater repair patches can be purchased at your local pool / hardware store. For
external use, use the repair patch provided. For internal holes, clean the hole on the inside of the pool to wipe off any oils and algae. Cut a circle large enough to
cover the hole and apply the patch securely onto the side in the water. Cut a second patch and apply to the outside of the pool for extra strength. If the hole is in
the base of the pool use one patch only and weigh it down with a heavy object while it bonds. For a hole in the top ring, inflate the ring to locate the hole, mark the
hole so you can see it easily and apply the patch pressing down firmly. Once it is applied deflate the ring slightly to take some of the pressure off the patch. If the
ring is completely deflated and the pool is empty put a heavy weight onto the patch to assist in bonding. If you have patched the pool when it is empty we
recommend you leave it at least 12 hours before filling.
7. Where can I buy filter cartridges and how often should I change them?
Filter cartridges to fit your filter pump should be available from the store where you purchased your pool. If not, most mass retailers sell filter cartridges as an
accessory. If you are unable to obtain replacements please call our toll-free number and we will assist you in finding a source local to you. The cartridges should
be changed every 2 weeks dependent upon use of the pool. Check the filter on a weekly basis and clean by hosing down any debris and particles. Note: Ensure
your pump is disconnected from the electrical supply before checking the filter cartridge. You can also visit our website www. bestway-service.com for cartridge
purchase.
8. How many times a year should I change the water?
This is dependant on the amount of use the pool receives, and the attention paid to covering the pool and keeping chemicals properly balanced. If maintained
correctly the water should last a full summer season. Please contact your local pool chemical supplier for detailed information regarding chemicals, they will be
able to advise you how to best maintain the cleanliness of your water.
9. Do I need to take my pool down for the winter?
Yes, Above-ground pools may collapse under the weight of ice and snow and the PVC walls will be damaged. We recommend taking the pool down when
temperatures fall below 8 º C / 45 º F. The pool should be stored indoors in a moderate temperature between 5 º C / 41 º F and 38 º C / 100 º F. Please store away
from chemicals and rodents and out of the reach of children.
10. My pool is fading – why is that?
Excessive use of chemicals can cause the color of the inside of the liner to fade; this is similar to a swimsuit fading over time from repeated contact with
chlorinated water.
11. How many years will the pool last?
There is no set time limit for the pool to last; following the instructions in the owner's manual and with proper care, maintenance and storage you can
considerably increase the life of your pool. Improper set-up, use or care can result in failure of the pool.
12. Do you recommend the use of a filter pump with a Bestway Fast Set pool?
Absolutely! We strongly recommend you the use of a filter pump which could maintain the water of the pool clean.
13. Which are the most important functions of my filter pump?
The most important function of a filter pump is the elimination of every sort of impurity from the water by the aid of a filter cartridge and chemical products for its
sterilization.

Frequently Asked Questions

8
Bestway
®
S-S-000662