Axis Communications P12 Série Guide D'installation page 16

Page 16
AXIS P1214/AXIS P1224-E Sensor Unit
!
IMPORTANT! - The casing of the AXIS P1214 sensor unit is not approved for outdoor
use - the product may only be installed in indoor environments.
The AXIS P1214/AXIS P1224-E can be mounted behind any wall, with just a small opening for the
lens, or with the whole lens assembly protruding through the wall.
1. Drill a hole with 20mm diameter in the wall, either completely through the material, or use a
countersink cutter to have a smaller opening.
2. Pull off the protection on the adhesive and attach the mounting bracket to the wall. Optionally
secure the bracket with two screws through the holes.
3. Insert the camera and tighten the lock ring as shown in the image below. Position the camera
so that the flat surface on the thread is vertical or horizontal.
4. Proceed to Connect the cables, on page 19.
AXIS P12 Series Installation Guide
Lock ring