CONFORAMA SABA TGV60N3F/C Mode D'emploi page 81

2 Adjustment of minimum level of the flame.
Control handle
Tap
1. Turn the taps down to minimum.
2. Remove the knob from the tap and place a small bladed
screwdriver in the centre of the tap shaft.
3. The correct adjustment is obtained when the flame has a
length of about 3 - 4 mm.
– For butane/ propane gas, the adjusting screw must be
tightly screwed in.
– Refit the control knob.
Make sure that the flame does not go out by quickly turning
from maximum flow to minimum flow. If it does then
remove the control knob and make further adjustments to
the gas flow, testing it again once the adjustment has been
made.
4. Repeat this process for each one of the gas taps.
Sealing ring
Adjustment screw
GB
36