CONFORAMA SABA TGV60N3F/C Mode D'emploi page 76

(A) SEALING STRIP
GB
(B) BRACKET
(C) SCREW
31
1. Place the bracket (B) over
the holes that match the size of
the screws.There are one set of
screw holes in each corner of the
hob (H) .
Slightly tighten a screw (C)
through the bracket (B) so that
the bracket is attached to the
hob, but so that you can still
adjust the position.
2. Carefully turn the hob back
over and then gently lower it
into the aperture hole that you
have cut out.
3. On the underneath of the
hob, adjust the brackets into a
position that is suitable for your
worktop.
Then fully tighten the screws (C)
to secure the hob into position.