CONFORAMA SABA TGV60N3F/C Mode D'emploi page 61

head in the event of the flame going out.
To ignite a burner:
• Press in the control knob of the burner that you wish to light
and turn it anti-clockwise to the maximum position.
• If you keep the control knob depressed, the automatic ignition
for the burner will operate.
• You should hold down the control knob for 15 seconds after
the flame on the burner has lit. If after 15s the burner has not
lit, stop operating the device and open the compartment door
and/or wait at least 1 min before attempting a further ignition
of the burner.
• After this 15-second interval, to regulate the flame you should
continue turning the control knob anti-clockwise until the
flame is at a suitable level. The operating position MUST be at a
position between the maximum and minimum position.
• To switch the burner off, turn the control knob fully clockwise
to the gas off position.
• In case of power failure, the burners can be lit by carefully
using a match.knob fully clockwise to the gas off position.
• In case of power failure, the burners can be lit by carefully
using a match.
GB
16