Vacuum Operation - Black & Decker BV3600 Manuel D'instructions

The blower tube must be assembled
to the housing before use.
• Hold the blower with both hands as
shown in figure K and sweep from
side to side with the nozzle several
inches above the surface. Slowly
advance keeping the accumulated pile
of debris in front of you.

VACUUM OPERATION

NOTE: Ensure the vacuum is switched off and disconnected from
the power supply before attaching or removing the vacuum tube.
The vacuum tube and collection bag
must be assembled to the housing
before use in vacuum mode.
• Position the vacuum tube slightly
above the debris/leaves. Turn the
unit on, then using a side to side
sweeping motion the debris/leaves
will be sucked up the tube, mulched
and deposited into the collection
bag (figure L) .
CAUTION:
NEVER REMOVE THE COLLECTION BAG
WITHOUT FIRST TURNING OFF AND UNPLUGGING THE VACUUM.
As the bag fills the power of the suction will decrease. To empty
collection bag, switch off the vacuum and and disconnect tool from
the power supply. Remove the collection bag from the power head,
unzip the collection bag to empty. Re-assemble before continuing
to operate.
D K
D L
WHAT TO DO IF THE UNIT JAMS: (FIGURE M)
CAUTION:
TURN OFF UNIT AND DISCONNECT TOOL
FROM POWER SUPPLY.
If the unit motor stops, the fan has
become jammed. If this happens, turn
the unit off and disconnect from power
supply. Remove the bag and vacuum
tube. Remove the jamming material
using a small wooden stick. Do not use
a metal implement or anything, which
may damage the fan or scratch the
plastic. Ensure the fan will turn by hand
before reassembling the unit.
If the unit stops picking up debris or
the performance substantially
reduces it may have become clogged. Switch the unit off and
disconnect from power supply. Remove the vacuum tube and look
down the tube to ensure no debris is blocking it. If necessary remove
debris with a small wooden stick. Do not use a metal implement or
anything, which may scratch or damage the tube. Remove the bag.
If the bag is full, empty the bag. If necessary remove any debris
from around the fan or unit outlet using a small wooden stick. Do
not use a metal implement or anything which may damage the
fan or scratch the plastic. Ensure the fan will turn by hand before
reassembling the unit.
7
D M