CyberPower PR1000ELCDRT2U Manuel D'utilisation page 9

1. General Mode:
a. Press the "Display-Toggle" button to check the status of the UPS status:
b. Press and hold the "Display-Toggle" button for 4 seconds,
If the machine is in the Battery Mode with active alarm, it will become silent.
If the machine is in the Line Mode, a self- diagnostic test will take place.
c. If the "Display-Toggle" button remains untouched for over 30 seconds, the LCD backlight will turn off
automatically.
2. Set-up Mode
Step 1: Hold the "Display-Toggle" button for 10 seconds to enter the UPS Set-Up Mode.
Step 2: By pressing the Display toggle, users can switch between setup functions. Some User Configurable
functions are as follows:
a. Sensitivity: Set the level of tolerance for UPS. Increase the UPS compatibility for local utility power
condition.
High: The UPS will turn to battery power more often to provide the steady power supply to the
connected equipment.
Low: The UPS will tolerate more fluctuations and turn to battery power less often.
b. Voltage Mode: The AC output voltage on battery mode. There are 3 different settings (220,230,240).
c. Battery Lifetime: Show the batteries already used time. Reset the logger when battery module
replacement or first time installation. Note: CLr is the command on LCD to reset Battery Lifetime.
These programmable items are sorted by unit as in the following table
Step 3: Press and hold the display-toggle for 4 seconds. When the icons blink, the value of each item is
changed by slightly pressing the toggle.
Step 4: To save the value and return to general mode, press and hold the toggle for 4 seconds.
Note! If the UPS is left idle for over 30 seconds during setup, it will turn off the backlight and return to
general mode automatically.
Note! If the user does not want to save the new settings and return to the general mode, there are two
methods:
(1) Wait for the backlight to turn off, or,
(2) By pressing and holding the "Display-toggle" key for 10 second.
Copyright © 2015 CyberPower Systems, Inc.
LCD SETUP FUCTIONS
Item
1 Input Voltage
2 Output Voltage
3 Output Frequency
4 Load
5 Estimate Run Time
6 Load Capacity
7 Battery Capacity
8 Centigrade
9 Fahrenheit
Items
Sensitivity
Voltage Mode (220/230/240)
Battery Lifetime
Firmware Version
Unit
V
V
Hz
Kw
Min
%
%
° C
° F
Unit
None
V
Y
None
8